Manual: RTI NEO SIX RGB 2
page 8 / 30
8. Operation
1.
Power
Make sure that your device is provided with the correct voltage. Wrong voltage could lead
to irreparable damages. Please find the correct voltage data in the synoptical table at the
end of this manual as well as at the rear side of the device. It must be ensured that the
device is not directed to people or inflammable objects during installation.
Connect the power cable to ‚Power in‘ at the device and then to the mains.
2.
DMX in / DMX out
The device can be controlled via DMX. There are a ‚DMX in‘ (DMX input) and a ‚DMX out‘
(DMX through) interface on the rear side of the device. Connect ‚DMX in‘ via a DMX cable
to a DMX controller. ‚DMX out‘ is intended to Daisy Chain the control signal to the ‚DMX
in‘ interface of a further RTI NEO device. The LED shows if there is any signal present. It
does not flash if there is a corrupt signal coming in.
The device offers 60 channels, starting from the selected start address. Each universe can
control a maximum of 8 devices and each of the 6 outputs can be controlled individually.
Each output of the device uses 10 channels as shown here:
Channel
Value
Effect
Comment
1 Red
0 - 255
Red: 0 - 100%
2 Green
0 - 255
Green: 0 - 100%
3 Blue
0 - 255
Blue: 0 - 100 %
4 Pan Coarse
0 - 255
Pan MSB
5 Pan Fine
0 - 255
Pan LSB
6 Tilt Coarse
0 - 255
Tilt MSB
7 Tilt Fine
0 - 255
Tilt LSB
8 Off / Dot / Gobo 0
Blackout
Safety channel
1 - 10
Dot
11 - 20
Rectangle
21 - 30
Triangle
31 - 40
Line horizontal
41 - 50
Line vertical
51 - 60
2 dots horizontal
61 - 70
2 dots vertical
71 - 80
3 dots horizontal
81 - 90
3 dots vertical
91 - 100
Circle
101 - 110
4 quarter circle
111 - 120
Test picture
121 - 130
Rectangle with grating