16
GB
Slope function up to max. 2.5°
Activation of the slope function deactivates the automatic sensor, Press the H
slope button and hold it down for at least 3 seconds until the auto LED starts
to blink very rapidly. Motor-driven adjustment of the slope can now be carried
out. Hold the V1 or V2 button down continuously to adjust slope. When the
lasers blink, the maximum slope range has been reached. The H slope button
(pressed briefly) is used to switch over between axes. Refer to the illustrations
below.
TIP: Switch the required laser lines on before you activate the slope function.
Rapid blinking: Set-up phase
Constant illumination: levelling completed.
Horizontal and vertical levelling
Switch the laser device on. The automatic sensor is now active and will level
the laser device automatically. As soon as device-levelling is completed and
the auto LED illuminates continuously, horizontal or vertical object levelling
can be carried out. Maximum accuracy is attained when device-levelling is
completed. Lasers can be switched on and off individually with the H-slope,
V1 and V2 buttons (press buttons briefly).
If the unit is placed at an excessive angle (out of its 2,5° range), the
lasers will blink. If this should be the case, align the unit roughly with
the levelling feet (7) or place it on a more level surface.
!
For the slope function, laser lines are no longer aligned to the
horizontal or vertical plane. This is a specific peculiarity of adjusted
laser lines. To reinstate horizontal or vertical levelling,
deactivate the slope function. Do this by switching the device
off then on again.
!
