I
TROUBLESHOOTING
Incorrect operations
are often mistaken for trouble and malfunctions.
If you think that there is something
wrong with this component,
check
the points below. Sometimes
the trouble
may lie in another component.
Investigate the other components
and electrical appliances
being
used.
If the trouble
cannot be rectified even after exercising
the checks listed below, ask your nearest PIONEER authorized
service center or your
dealer to carry out repair work.
Symptom
Cause
Remedy
1. Disc table is not ejected
when
.Power
cord is not properly
plugged
into AC
• Plug in power cord.
~ is pressed.
wall socket.
• Power switch is not turned on.
• Turn on power switch.
2. Disc table comes out.
.Disc
is dirty.
• Clean disc.
• The disc is not properly
set on the disc table.
• Set the disc properly.
• Moisture has condensed on parts in the player.
• Remove
disc and let player stand for 1 to 2
hours until it is dry .
• Disc is warped.
• Change the disc.
3. Remote control does not work.
• The CONTROL IN terminal
on the rear panel is
.Aim
the remote control
unit at the projection
connected
to Pioneer projection
monitior
or
monitor
or AV amplifier.
AVamplifier.
• Batteries are weak.
• Replace batteries.
• There is an obstacle
between the player and
• Remove the obstacle or shift the remote control
the remote control
unit.
position.
• Remote control
unit is not in a good location
• Operate the remote control unit in front of the
for transmission.
player.
4.
Operation
of the remote control
• Some TV sets have remote control
functions
• Move the TV and the player further
apart, or
unit causes the TV
to operate
that operate
improperly
in response
to the
cover the remote sensor of the TV during disc
improperly.
remote control
unit of the player.
playback.
Abnormal functioning of this unit may be caused by static electricity,
or other external interference. To restore normal operation, turn the
power off and then on again, or unplug the AC power cord and then
plug it in again.
26
<VRBl139>
En
