LaserBit LB Series 4.3 page
60
network. The SC-SC connector is a reversible part, so you can connect in the first
plug where you want, the important is that the two plugs of the head have to be on
one side, and the two plugs of the network have to be on the other, and if you plug in
the transmitter side of the head into a connector, then the transmitter side of the
network have to be in the opposite connector of the previous, and do the same with
the other sides too.
10.4.6
Connecting to the management
If you have a TP head
Using the RJ11 Sevice Connector you
can connect your management indoor
unit to the head, and you can measure
the detector voltage of the receiver of
the head as well.
More details about the management
please find to see its own Users’
Manual.
If you have a TC head
Using the RJ11 Sevice Connector and
the two green connectors you can
connect your management indoor unit to
the head.
The necessary signals can be found on
the blue and blue-white wires of the
head power cable. You have to connect
these two wires into two pins of the four
of the two green connectors. These pins
are connected to the pins of the RJ11
Service Connector. The order of
connections is the following:
Pin of the green connector 4
5
7
8
Pin of the RJ11 Service Connector 4
5
3
2
More details about the management please find to see its own Users’ Manual.
(please connect the blue and the blue-white wires to the Pin number 4&7 in case of
The Web-Based LB-View MGM unit)
