LaserBit LB Series 4.3 page
59
End of the alignment
•
Switch on all of the transmitters!
•
Plug the motor controller cable back to the slot!
•
Close up the covers of the heads!
10.4.5
Connecting to your Network
If you have a TP head
You can find a TP connector
unit in your ODIU, with there
connectors. You have to plug in
the TP cable of your head into
the RJ45 connector. Your
network is connectable to the
LB system using the white one
rowed connector, where you
have to connect the four cable
of your network with the help of
the punch down tool. The order
of the cable can be seen on the
figure.
The punch-down tool
Place your first cable on the top of the chosen
connector, without removing the insulator from the
cable. Then using the punch down tool push down the
cable into the connector.
If you have a TC head
You can find a two sided fibre
connector in your ODIU. You have to
connect the fibre cable of your head
into the one side of the connector, and
into the other side you have connect
the fibre cable of you network
equipment (switch; router or LB
combiner). The fibre plugs of the
heads are always SC typed, which
means that them cross-sections are
cubic form. The fibre connector in the
ODIU is SC-SC typed, so you have to
provide an SC fibre plug for you
