SPK-IPT200
USER MANUAL
6
3.
To disable Alarm 1, press the MEM/TIME/PLAY/PAUSE button (3) twice once the alarm has been
cancelled or snoozed.
4.
Then press the VOL-/ALARM1 button (5) repeatedly until the alarm option is blank (meaning no
alarm will sound).
5.
Press the MEM/TIME/PLAY/PAUSE button to store the setting. You will notice the ALARM1 icon
has gone from the display
6.
Repeat steps 3 to 5 to disable Alarm2, but remember to press the MEM/TIME/PLAY/PAUSE
button (3) three times. Then press the VOL+/ALRM2 button (7) repeatedly until the alarm option
is blank. Press the MEM/TIME/PLAY/PAUSE button to store the setting
Note 1: If you set the alarm mode to IPOD but there is no iPOD present in the dock when the alarm
sounds, the BUZZER will be used by default
Note 2: When using iPod alarm mode, please ensure the last used mode is audio and not video
Note 3: There is no alarm function for the AUX input mode
SLEEP FUNCTION
The sleep function allows you to set a period of time before the unit will enter the STANDBY mode
1.
During the playback of any the sources eg. iPad, Radio, & AUX input, press the SNOOZE/SLEEP
button (6) repeatedly to cycle through the sleep interval options. These range from 90 minutes
down to 10 minutes in 10 minute increments
2.
When the timer expires the unit enters STANDBY mode
3.
To intervene and cancel the SLEEP function at any time, press SNOOZE button until 00 is seen on
the display. Or press and hold the STANDBY button to enter standby mode
ADJUSTING THE VOLUME
To increase the volume level press the VOL+/ALARM2 button (7), to decrease the volume level press
the VOL-/ALARM 1 button (5)
LISTEN TO THE RADIO
Note: For best FM reception extend the antenna wires located on the rear of the unit. It is important
not to alter or attach other antennas to this antenna wire
1.
Press the MODE/STANDBY button to switch the unit ON if in STANDBY mode
2.
Press the MODE/STANDBY button repeatedly until you reach the RADIO function icon. You will
also see the radio frequency in large digits
3.
To tune in a station press an hold the TUNE-/BACK button (4) to scan down the frequency range
or TUNE+/FORWARD button (8) to scan up the frequency range. Keep you finger on the button,
until the next radio station is found. The scan will then stop. Repeat as needed.
4.
To set a frequency manually press the TUNE-/BACK button to skip down the frequency range in
0.1MHz increments, Pressing the TUNE+/FORWARD button skips up in 0.1MHz increments
SETTING RADIO STATION FAVOURITES / PRESETS
You can store up to 10 preset stations for quick access
1.
Press and hold the MEM/TIME/PLAY/PAUSE button (while in RADIO mode), you will see 1 MEM
(the number digit will flash)
