SPK-IPT200
USER MANUAL
4
WHAT’S IN THE BOX
SPK-IPT200, Power adaptor, user manual
FITTING THE BACK-UP BATTERY
1.
Remove the battery compartment cover from bottom of the unit
2.
Insert 2 x AAA batteries into the compartment, taking note of the polarities marked on the inside
of the compartment
3.
Replace the battery compartment over
Note : Batteries for clock settings backup only
STAND-BY MODE
1.
When the power adaptor is connected, press the STANDBY button (9) briefly to switch ON or to
switch MODE’s.
2.
Press and hold ( for 2 seconds) to enter STANDBY mode
SETTING THE TIME
Note: The clock can only be set in STANDBY mode. Any loss of power without backup batteries
installed will result in erased settings (the stand by screen is dimmed slightly)
1.
Press the MEM/TIME/PLAY/PAUSE button (3) once. The clock display will then flash
2.
Press the TUNE-/ BACK button (4) repeatedly until the HOUR digit is correct. Repeat for the
MINUTE digits then using the TUNE+/ FORWARD button (8)
3.
Once the digits are set to the current time, leave all buttons for a few seconds to store the
setting. The digits will stop flashing when completed.
Changing to 24hour time
Note 1: In order to set 12 or 24 hour time mode, you need to be in either DOCK or AUX mode. The radio
mode will not allow this setting
