March 19, 2018
HogNose building instructions
21
Step 45
With the receiver still attached and the correct
way up:-
Feed the other ends of the rods through the holes
in "F5" and "F6" which are marked "E" for the
elevator rod and "R" for the rudder rod.
It's the outer 2 holes in "F5" and the upper 2 holes
in "F6". (This view is of the underside).
The other holes are not used but may help if
fitting your own receiver.
And finally out through the slots in the
fuselage sides through piece "C".
These rod have been pre-cut to length
and should not require further
trimming.
Now fit the receiver into the receiver
tray and check it is fully located in the
small notches in the plastic receiver
clip. (SEE BELOW).
Step 44
E
R
Slot in "C" fuselage side.
Elevator pushrod
Rudder pushrod
Nose
Fit the receiver
to this slot first
Gently push
until the receiver
clicks into position
Note:- Push rods not shown in
this view for clarity.
To fit the receiver into the receiver
tray.
Locate the "V7" lettering on the
receiver and engage this part of
the receiver into the rear notch of
the plastic receiver clip.
Then gently push the front of the
receiver down until it engages in
the front clip.
"V7"
Fitting the receiver into the tray.
Tail