5
Copyright 2005 Laser Arts
6.
Glue in the 2 F6 1/8” balsa doublers between F3 and F4 as shown below. Make sure that the engraved text is to the inside of the
fuselage and to the front of the fuselage and that the bottom is flush with the bottom of the fuselage sides. Make sure you clean up
any excess glue that seeped out.
7.
Glue the 1/8” balsa bottom to the fuselage assembly as shown below. If there is a little extra material, it should extend in front of
F1.
8.
Glue the ¼” boom reinforcement blocks into the fuselage as shown in the image below. PLEASE NOTE that the boom is shown as
reference only, do NOT glue the boom in yet.
