Larson Electronics, LLC
Phone:
877-348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
6
of
1
0
ACCESSORY & CONTROL WIRING INSTALLATION (cont.)
Detail
AX / AL 3 wires / cables / fils
24 AWG (0.20 mm
2
)
AX / AL
SHT or UVT
AX / AL
<Fig. 7>
Control Wiring Installation / Instalación de cable de control / Installation de câblage de contrôle
BUS
INSTALLATION
HAZARD OF ELECTRIC SHOCK, BURN, OR EXPLOSION
WARNING:
MAKE SURE POWER IS TURNED
OFF
BEFORE STARTING THE
INSTALLATION OR PERFORMING ANY MAINTENANCE.
1.
Apply appropriate personal protective equipment and follow safe electrical work practices.
2.
This equipment must be installed and serviced only by qualified electrical personnel.
3.
Turn off all power supplying this equipment before working on or inside equipment.
4.
Always use a properly rated voltage sensing device to confirm power is off.
5.
Replace all devices, doors and covers before turning on power to this equipment.
FAILURE TO FOLLOW THESE INSTRUCTIONS WILL RESULT IN DEATH OR SEVERE INJURY
1. Change terminal mounter assemblies (A) to terminal assemblies (B), if installed.
2. Install bus, using supplied hardware (C) (D).
3. Do not exceed torque specification of screws or bolts (E).
<Table.4 / Tabla.4 / Tableau.4>
Bus and Bus Insulation Dimensions /
Dimensiones de la barra y del
aislamiento de la barra / Dimensions
de la barre-bus et de son isolation
Dimension/
Dimensiones/
Dimension
Length/
Longitud/
Longueur
0.164in
(4.16mm)
A
B
C
D
E
0.08~0.28in
(2~7.2mm)
0.35in
(9mm)
0.47in
(12.1mm)
0.29in
(7.4mm)
MPD-XX-CB-SF-489
Series
