background image

Larson Electronics Contact

Phone: 1-877-960-2536 (1-214-891-7441 for international inquiries)

Email: [email protected]

Fax: 1-903-498-3364

Larson Electronics, LLC

 

  Phone: (800) 369-6671 

 Fax: (903) 498-3364 

 www.larsonelectronics.com 

5

 of 

5

THESE  INSTRUCTIONS  MAY  NOT  COVER  ALL  DETAILS  OR  VARIATIONS  OF  THIS  PRODUCT  FOR  YOUR  EQUIPMENT  OR  INSTALLATION  REQUIREMENTS.  SHOULD  FURTHER 
INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT 

[email protected]

 OR BY PHONE AT 

1-800-369-6671 FOR FURTHER ASSISTANCE. 

PLEASE VISIT LARSONELECTRONICS.COM FOR 

WARRANTY

 AND 

RETURN

 INFORMATION.

 GL-2XXXGT Series

PRODUCT SAFETY WARNINGS

 WARNING: You risk death or serious injury to yourself and others if you do not follow the instruction highlighted by 

the warning symbol. Failure to follow the specific warnings and instructions could result in personal injury, fire or 

electrical shock.

 WARNING: This light is for off-road and utility use only. It is not designed or approved for road use as a driving 

light.

 WARNING: The RadioRay complies with Part. 15 of

 

the FCC Rules.  Operation is subject to the following two 

conditions:  (1) This light and remote may not cause harmful interference, and (2) this light and remote must accept 

any interference received, including interference that may cause undesired operation.

 WARNING: Changes or modifications made by the user not expressly approved by Larson Electronics for 

compliance could void the user’s authority to operate the equipment.

 WARNING: This spotlight is not approved for use inside a vehicle or enclosure and power should be disconnected 

prior to placing the light in such circumstance.

 WARNING: This spotlight is not approved for underwater use.

PRODUCT MISUSE

This spotlight is not approved for inverted mounting
This spotlight may be damaged if operated in icing conditions
This spotlight may only be disassembled and repaired by an authorized Golight®  representative
This spotlight should not be turned on when snap on lens cover (rockguard) is attached.
Any violation of the above referenced misuses or warnings will be considered grounds for warranty refusal

Summary of Contents for Golight GL-2 GT Series






Reviews: