Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
10
This device meets the CAN ICES-3 (A)/NMB-3(A) standards requirements.
Safety Instruction
These instructions are intended to ensure that the user can use the product correctly to
avoid danger or property loss.
The precaution measure is divided into ‘Warnings’ and ‘Cautions’:
Warnings
: Serious injury or death may be caused if any of these warnings are
neglected.
Cautions
: Injury or equipment damage may be caused if any of these cautions are
neglected.
Warnings
Follow these safeguards to
prevent serious injury or death.
Cautions
Follow these precautions to
prevent potential injury or material
damage.
Warnings:
This installation should be made by a qualified service person and should conform
to all the local codes.
Please install blackouts equipment into the power supply circuit for convenient
supply interruption.
If the product does not work properly, please contact your dealer or the nearest
service center. Never attempt to disassemble the camera yourself. (We shall not
assume any responsibility for problems caused by unauthorized repair or
maintenance.)
Make sure the supply voltage is within the voltage rating.
Ensure that the marked T rating is less than the ignition temperature of the
hazardous atmosphere.
DO NOT operate in ambient temperatures above those indicated on the product
nameplate.
DO NOT operate if the lens, cord, seals, housing, receptacles, etc. are cracked or
damaged. If so, discontinue use and contact manufacturer for replacement parts.
All fasteners should be properly seated.
IP Camera Network Setup Guide
TO AVOID EXPLOSION:
