EXP-MS-N4X-AT-HV
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
5
of
6
•
Center the board in the container so the two sensors on top are not covered.
•
Using a
9/64 Allen Wrench
, tighten and secure the bolts on this container to secure
the board in place.
•
When tight enough so the unit doesn't shift in place, use a 6mm Socket Wrench to
tighten and secure the nuts on the other side of the container.
•
Once the unit is fully secured, feed the wires back through the unit and slide
the container into the unit.
•
Screw the lid back onto the fixture and remount to desired location.
•
Connect fixture back to power and continue use.
