EXP-MS-N4X-AT-HV
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
4
of
6
NOTE:
The starting
socket
, the one labeled
"Mandatory start line", is not needed for
connections and can be left alone and skipped
during installation.
INSTALLATION
•
Disconnect the fixture from all power sources and esnure it is cool to the touch.
•
Remove the fixture from the mount.
•
Open up the fixture and locate the housing unit containing the motion sensor board.
•
Carefully remove the housing unit from the enclosure.
•
To remove the board from the wiring connections, press down on the white tabs
to release the wiring.
•
After all connections in the original board are removed, set it to the side.
•
Grab new replacement board and make the wire connections as before.
o
Just push down the white tab and insert the wire into the correct slot.
•
The housing unit for the board has a notch built into the bottom section of the
container. This notch is for the wire connections between the board and the
unit to feed through.
