8.
Using the drop-down menus as described in the Access-T manual,
verify that passwords are disabled on the Access-T unit.
General Downloading Procedure
1.
Determine which Software Distribution Diskette is to be used. Use
Diskette
#1
when downloading to an Access-T Series 200, 400, or 1500 unit
(part # 087-0861-xxx-xx). Use
Diskette #2
when downloading to an
Access-T 01/02 unit (part # 087-0511-xxx-xx). Use
Diskette #3
when
downloading to an Access-T 100-S unit (part # 087-347D-101-xx). Use
Diskette #4
when downloading to an Access-T 100-RDL unit (part #
087-402D-101-xx).
2.
To begin a download session, place the appropriate Software Distri-
bution Diskette in the appropriate drive and select that drive. For
example, enter
B
: if the diskette is inserted in drive B.
3.
Type
DLEX
followed by the
Enter
key to start the download program.
4.
Wait for the following display of command options:
Commands are invoked by entering the letter which is capitalized
in the display. (Commands can be entered in upper or lower case.
Pressing the
Enter
key is not required.) Commands are defined in
Table A.
5.
Enter
C
and select the appropriate device type from the prompt:
Setup Device Configuration Type
Enter 1 for 087-0861 -xxx-xx, 2 for 087-0511-xxx-xx
3 for 087-347D-101-xx, 4 for 087-402D-101-xx
Enter
1
when downloading to an Access-T Series 100, 200, 400, or 1500
unit. Enter
2
when downloading to an Access-T 01 /02 unit. Enter
ACCESS-T 2/4 PORT PC Download Program—D87-158D-201
(SINGLE-CARD DOWNLOAD SETUP)
port = 1 baud rate = 2400 chain port add. = 0 Device = 087-0861-xxx-xx
Command:--Baud--moDem commands--Escape--loGin--Hang up--dIal--load Mux
--load Nim--logOut--Port--Rtrv secu--tabs Status--card_resTart--ed secU
--Whole download--Larscom setup--chAin port address--all-in-one-Flash
--deviCe type--eXit
Larscom Access-T 100, 200, 400, & 1500 Network Access DSU/CSU
ACST-6351-001
Software Downloading Instructions
October 1996
4
