Rack-Mounting the Access-T 100-S or Access-T RDL
Before attempting to rack-mount the Access-T 100-S or Access-T RDL, please
verify that you have the following:
•
Access-T 100-S or Access-T RDL.
•
Single Rack-Mount Accessory Kit (LP#: A87-AK14-001) OR Dual
Rack-Mount Tray Accessory Kit (LP#: A87-AK13-001).
•
Phillips screwdriver.
If you did not receive the single- or the dual-rack-mount accessory kit, please
call Larscom to obtain these parts.
To rack-mount a single Access-T 100-S or Access-T RDL:
1.
Attach the mounting ears (found in the Accessory Kit) to the sides of the
unit using a Phillips screwdriver and the screws and washers provided.
The mounting ears can be installed in a flush or center-mount position,
and can be reversed to accommodate 19- or 23-inch racks.
2.
Secure the Access-T to the equipment rack.
To rack-mount the Access-T 100-S or Access-T RDL with the dual rack-mount
tray:
1.
Using a Phillips screwdriver, secure the Access-T mounting tray to
the equipment rack. Be sure to use only the two lower holes on the
mounting tray.
2.
Mount the Access-T onto the tray as follows:
a.
Attach the mounting bracket to the top-left corner (if positioning
the unit to the left side of the tray) or top-right corner (if position-
ing the unit to the right side of the tray) of the Access-T chassis.
b.
Slide the Access-T into the tray so that the unit mates with the
guide pin in the rear of the tray. The mounting ear should line up
with the tray’s upper mounting hole.
c.
Using a Phillips screwdriver, secure the Access-T to the tray.
3.
If you are installing a second Access-T, repeat Step 2 for the second
unit.
Note:
The dual rack-mount tray can be used only with
19-inch equipment racks.
ACST-0351-S53
Larscom Incorporated
December 1996
Supplement 3, ACST-0351-005
3
