Larscom Access-T 100, 200, 400, & 1500 Network Access DSU/CSU
Software Downloading Instructions
This document provides instructions for downloading Access-T software from
a personal computer (PC), directly or via modems. Access-T software consists
of two parts: Network Interface Module (NIM) software and Multiplexer Mod-
ule (Mux) software. The download procedure allows you to download software
to Access-T Series 100, 200, 400, and 1500 units and Access-T 01 /02 units, as
follows:
•
Download NIM and Mux software to one Access-T Series 100,
200,400, or 1500 unit (either directly or via the chain).
Note:
Downloads to the Access-T 100-S or the
Access-T 100-RDL are done through the craft port
only.
Caution: Downloading through the chain port
supports an all-in-one flash download. If all
your Access-Ts along the chain are not identical,
downloads to the individual modules should be
made via the individual craft ports.
•
Download NIM and Mux software to the master Access-T Series 100,
200, 400, or 1500 unit as well as to all slaves on a chain.
•
Download software in an Access-T Series 200,400, or 1500 unit’s flash
memory to its own or a slave’s internal board(s).
•
Download NIM and Mux software from diskettes to Access-T 01 /02
(older model).
•
Download NIM or Mux software from diskettes to Access-T 01/02
(older model).
Note:
Access-T 1500s can contain up to 15 modules
(cards). When this document refers to downloading to
an Access-T 1500 unit, it refers to one or more modules.
ACST-6351-001
Larscom Access-T 100, 200, 400, & 1500 Network Access DSU/CSU
October 1996
Software Downloading Instructions
1
