ZEUS
16
English
H
SPRAY ADJUSTMENT
•
Slowly turn clockwise the pressure control knob (
G4
) to reach
the pressure value in order to ensure a good atomization of
the product.
NEVER point the spray gun at yourselves or at
other people. The contact with the casting can
cause serious injuries.
In case of injuries caused by the gun casting, seek
immediate medical advice specifying the type of
the product injected.
The valve (
G2
) serves two purposes:
•
Safety:
It opens the passage at pressure peaks exceeding
280÷300 bar;
•
Regulation:
It returns the working pressure to 230 bar and
levels out the hydraulic operating hysteresis.
Safety valve: when working at the maximum pres-
sure available, releasing the gun trigger sudden
increases of pressure can occur. In this case, the
safety valve (G5) opens automatically eliminating
part of the product from the recirculating tube (G6).
Then it closes so as to go back to the first working
conditions.
•
An irregular and marked spray on the sides indicates a low
working pressure. On the contrary, a too high pressure causes
a high fog
(“overspray”)
and waste of product.
•
In order to avoid overthickness of paint, let the gun advance
sideways
(right-left)
when spraying.
•
Always paint with regular parallel bands coats.
•
Keep a safety and constant distance between the gun and the
support to be painted and also keep yourselves perpendicular
to it.
CLEANING AT THE END
OF THE WORK
Make sure that the electrical system is earthed and
complies with regulations.
CLEANING FOR SOLVENT-BASED PRODUCTS
G4
G2
G5
