14
EXCALIBUR LINER
English
F18
G2
G3
G1
F13
F19
Repeat the same operations with clean solvent if
necessary.
• After having completed the wash operations, bring the han-
dle to its MIN position (
F17
) and point the gun (
F13)
into a
collection container (
F19
) and press the trigger to release
the residual pressure. Release the trigger when finished.
Absolutely avoid to spray solvents indoors. In
addition, it is recommended to keep away from
the pump in order to avoid the contact between
the solvent fumes and the motor.
• Shut off the equipment by turning the switch to its
OFF
position
“(O)”.
• Stop the combustion engine.
•
At this point the machine is ready. If water-based paints are
to be used, after the wash with solvent wash the tank again
with soap and water, then rinse with clean water
(repeating
the previously described procedures)
.
•
Insert the manual gun trigger lock and assemble the noz-
zle.
• Mix and filter the product before using it. For filtration
use
CLOSE-MESH
(rif. 214)
and
LARGE-MESH
(rif. 215)
LARIUS METEX
braids.
PRODUCT PREPARATION
MAKE SURE THE PRODUCT IS SUITABLE TO BE
USED WITH A SPRAY GUN.
Make sure the product to be used is compatible
with the materials employed for manufacturing
the equipment (stainless steel and aluminium).
Because of that, please contact the supplier of
the product.
Never use products containing halogen hydrocarbons
(as methy-
lene chloride)
. If these products come into contact with aluminium
parts of the equipment, can provoke dangerous chemical reactions
with risk of explosion.
• Fill the tank (
F18
) with the paint.
•
Remove the gun (
F13
) from its support and point it into a
container (
F19
). Hold the trigger down
(to perform the cle-
aning)
until clean solvent comes out, or else until all of the
wash fluid has been expelled from the tank.
G
REGULATIONS
ADJUSTING THE GUN SUPPORT ARM
In order to adjust the position of the spray gun (
G1
) use the
knobs (
G2-G3
).