Edit. 03 - 06/2019
www.larius.eu
CH 200 AD
13
OPERATION
After having carried out all the electrical and pneumatic connec-
tions as described in the previous chapter, proceed as follows:
•
Turn the revolving arm (
H15
) in order to be able to position
the cardboard box (
H16
) containing the powder on the
vibrating surface (
H17
) as illustrated in the figure.
•
Lift up the powder suction tube (
H18
). Loosening the lock-
ing ring nut (
H19
), it is possible to slide the suction tube
along the revolving arm.
•
Turn the revolving arm (
H15
) and position it above the
powder container.
•
Lower the powder suction tube (
H18
) inside the container.
•
Open the air supply to the machine.
•
Press the main switch (
H20
) of the control panel to power
the generator.
•
Turn the switch (
H21
) of the electric vibrator to the "ON"
position.
The electric vibrator is activated each time the
spray gun trigger is pressed and it automatically
stops every time the trigger is released.
USE WITH CH 200 SPRAY GUN (corona effect)
•
Point the spray gun inside the spray booth and hold down
the trigger to adjust the powder delivery setting.
•
Adjust the air pressure delivered to the powder supply
pump (
H18
), using the regulator (
H19
) and reading the
value expressed in bar on the pressure gauge
H20
) (max
recommended values 3-4 bar).
To use with the CH 200 spray gun (corona effect),
make sure the selector (H17) is in the "CORONA"
position.
H22
H20
H21
H19
H16
H17
H15
H18
