Edit. 03 - 06/2019
www.larius.eu
CH 200 AD
9
G
H
Follow the instructions included in the use and
maintenance manual.
•
Verify the integrity of the components and parts of the
machine.
•
Observe the instructions and warnings provided on the
machine, the safety warning labels on the machine must
always be perfectly legible.
•
Check the state of preservation
(cleaning)
and maintenance
of the machine and its main components.
•
Check the correct operation of the pneumatic system and
the condition of the pipes and fittings.
•
For all operations, always wear suitable clothing, in compli-
ance with workplace safety regulations.
•
Report any operating malfunctions
(faulty operation, sus-
pected breakage, incorrect movements and noise that exceeds
normal limits)
to the department manager and switch off
the machine.
•
Observe the maintenance schedule and record, after each
check, any observations concerning the maintenance
operation performed.
•
The powder must be stored in a cool and dry place, in sealed
containers that are subject to frequent stock turnover.
•
The surfaces of the piece to be treated must be free of any
contaminating agents and correctly pretreated.
•
The compressed air must not contain water or oil.
•
The piece to be treated must be correctly secured and
properly grounded.
•
The frames must provide good grounding for the piece.
•
The temperature of the furnace must be correct in order
to polymerise perfectly.
•
The powder feeders, the spray booth, and the recovery
system must be free of all contaminating agents and free
of any powder that is different than that chosen for use.
•
Pre-treatment and firing checks must be carried out peri-
odically during processing.
•
All the recycled powder must be sieved and mixed with
new powder observing the recommended proportions.
•
Do not use silicones or paints near the machine.
INCORRECT USE OF THE
SYSTEM
The company LARIUS considers "incorrect use" of the machine
to be any use that is not described in the previous paragraph and:
•
Do not point the spray gun jet at people.
•
Use of improper or inadequate energy sources.
If modifications must be made to the machine, you must
contact
LARIUS
in order to obtain the most up-to-date
technology.
The company LARIUS is not responsible for mechani-
cal damage to persons caused by incorrect uses as
described above.
In the event the customer must use the machine
with materials different than those cited in the sales
contract or modify the operating parameters, the
customer must contact LARIUS for new operating
parameters and technologies.
It is recommended that the operator in charge of the
machine's operation and the person responsible for
its maintenance, keep the safety and control areas
and the access area to the parts of the hoist, free
of all obstacles and equipment.
•
Use of the machine by personnel who is not adequately
trained.
•
Failure to comply with routine maintenance requirements
or maintenance operations performed improperly.
•
Use of non-original or unsuitable spare parts.
•
Modification or cancellation of safety device settings and/
or tampering with the various equipment.
•
Perform inspection, maintenance or repair operations
without having switched off the machine.
•
Make temporary repairs or carry out recovery interventions
that do not comply with the instructions.
CONTROL PANEL
The operation, adjustment, and stoppage of the system, as well
as the instructions concerning correct operation, are managed
by the control panel positioned above.
Install a disconnecting switch with fuses upstream
of the main switch, in order to completely isolate
the machine from the power supply network.
OPERATING CONTROLS
Buttons - Switches - Indicator lights - Potentiometers
The operating controls are located on the control panel and are
used directly by the operator during operation and to carry out
every maintenance or testing operation.
