ⓒ
2017
LaON
Technology Co., Ltd. All rights reserved.
28
BP150 BELT PACK OPERATION
POWER ON/OFF
Power On
Press the power button (#4, „PWR‟) longer than three (3) seconds to turn on the Belt Pack. A voice message “Power on” will be
heard from the headset, and the red TALK light adjacent to the TALK button will go on. After a few seconds, TALK light will be
changed to green slow flashing, indicating the Belt Pack is ready to use, if the pairing with the Mobile Station is properly done.
Power Off
Press and hold the PWR button for approximately two sec
onds. A voice message “Power off” will be heard in the headset and then
the green slow flashing TALK light will go off.
NORMAL MENU ON THE BELT PACK‟S UPPER PANEL DISPLAY
The item
„A‟
indicates the Belt Pack‟s Received Signal Strength Indication (RSSI) level. The RSSI level is
presented graphically
.
The item
„B‟
indicates
that the applicable Belt Pack is being connected to which station. When the Belt Pack is connected to the
Mobile Station, “MS” will be shown. When a Belt Pack is connected to a Master Belt Pack, “MB” will be shown.
The item
„C‟
indicates the Communication Group
of the
Belt Pack‟s headset. The numbers “1” and “2” stand for the number of
the
Communication Group channel
.
The item
„D‟
indicates the Belt Pack‟s battery level.
The battery level is presented graphically.
The item
„E‟
indicates the Belt Pack‟s label. While the KEY LOCK is set, „LOCK‟ will be indicated here to instead.
The item
„F‟
indicates Belt Pack‟s operation mode. If the headset of Belt Pack is in the hands-free-on mode operation, “HF on”
appears in the display. If the headset of Belt Pack is in the push-to-talk (Hands Free off) mo
de operation, “HF off” appears in the
display.
KEY LOCK SETUP
The Belt Pack keys can be locked to avoid any wrong operation unintentionally by accident. Press and hold the PWR button (#4)
of the Belt Pack and quickly press GRP button (#5) within one (1) second and release both. And the keys will be locked. In key
lock mode, SET (#7) and GRP (#5) button will be inactivated and the NORMAL menu of the Belt Pack will show the t
ext „LOCK‟
in the bottom-right of the screen. To unlock, press and hold the PWR button (#4) and quickly press GRP button (#5) within one
(1) second and release both again same operation as for locking.
NOTE 1:
Quickly operate to press the two buttons as instructed above otherwise, pressing PWR button longer than 2 seconds
will make the Belt Pack turned off.
Figure 4-18. NORMAL menu
A
B
C
D
F
E
MS
9
10
11
1
4
2
7
3
5
6
8
