4: Installation of xSenso 21A2
xSenso User Guide
32
To reboot the unit without resetting the unit to factory defaults:
1.
Place the end of a paper clip or similar object into the
RST
(reset) opening (see
Figure 4-2
)
and press and hold down micro switch during a power cycle for 3 to 5 seconds.
2.
Remove the paper clip to release the button. The unit will reboot.
Side Panels
The following are located on the side panels (
Figure 4-6
):
Right Side
Analog Input 1
Analog Input 2
9-30 VDC 3 Pin Terminal Block Power Input
9-30 VDC Barrel Locking Power Input
Left Side
Analog Output 1
Analog Output 2
Figure 4-6 xSenso, Side Views
Back Panel
On the xSenso back panel, there is a mounting bracket with a sliding orange clip which allows you
to mount and dismount the device from a DIN rail, as shown in
Figure 4-7
. There are also four
rubber feet that can be attached to the bottom-side of the device, if the xSenso is to be placed on
a flat surface.
9-30 VDC Barrel
Locking Power Input
Excitation Voltage Input
Current Input
Analog Analog
Output 1 Output 2
