Chapter 12: Monitor Mode
XPress DR+ User Guide
97
Table 12-1. Monitor Mode Commands
Command
Command Name
Function
AT
ARP Table
Shows the unit’s ARP table entries.
G0, G1, ....,Ge, Gf
Get configuration
from memory page
Gets a memory page of configuration information
from the device.
GC x.x.x.x
Get Configuration
Gets configuration of unit with IP address x.x.x.x as
hex records (120 bytes).
GM
Get MAC address
Shows the unit's 6-byte MAC address.
NC
Network Connection
Shows the unit’s IP configuration.
NS
Network Status
Reports the status of the network interfaces,
including negotiated parameters like speed/duplex
for Ethernet or BSSID, encryption, and
authentication for wireless interfaces.
PI x.x.x.x
Ping
Pings unit with IP address x.x.x.x to check device
status.
QU
Quit
Exits diagnostics mode.
RS
Reset
Resets the unit’s power.
S0, S1,...,Se, Sf
Set configuration to
memory page
Sets a memory page of configuration information
on the device.
SA
Scan
Initiates a wireless scan if the wireless interface is
enabled at the time. Reports any stations found,
including BSSID, SSID, and RSSI.
If SA is followed by a string, that string is used to
filter SSIDs before reporting.
Note:
If the BSS does not broadcast its SSID, only
the BSSID and RSSI are returned.
SC x.x.x.x
Send Configuration
Sets configuration of unit with IP address x.x.x.x
from hex records.
SS
Set Security record
Sets the Security record without the encryption key
and length parameters. The entire record must still
be written, but the encryption-specific bytes do not
need to be provided (they can be null since they
are not overwritten).
TT
TCP Connection
Table
Shows all incoming and outgoing TCP connections.
VS x.x.x.x
Version
Queries software header record (16 bytes) of unit
with IP address x.x.x.x.
Responses to some of the commands are in Intel Hex format.
Note:
Entering any of the commands listed above generates one of the following
command response codes
