Lantronix
SM24TBT2DPB Install Guide
33845 Rev. B
Page
30
of
48
Initial Switch Configuration via CLI
Use an RJ-45 cable to connect a terminal or PC/terminal emulator to the switch port to access the CLI.
Attach the RJ-45 serial port on the switch front panel to the cable for Telnet/CLI configuration.
Attach the other end of the DB-9 cable to a PC running Telnet or a terminal emulation program such as
HyperTerminal or Tera Term.
After powering up the switch for the first time, you can perform the initial switch configuration using the CLI
(Command Line Interface). For managing other switch features, see the
CLI Reference
for details.
Switch CLI Command Notes
The SM24TBT2DPB
show system
command:
The SM24TBT2DPB show power management command with one PS-ACDC-1200 power supply installed:
SM24TBT2DPB#
show power management
Power Management
=========================
Power : A B
Detected PSU : PSU-HV None
Power Good : Good Fail
Power Input(AC/DC) : Good Fail
Power Input Voltage (V) : 123 ---
FAN Speed (RPM) : 2911 0
Temperature (Degree C) : 42 0
Operating Mode :
Redundant
SM24TBT2DPB#
Note
: the PS-ACDC-1200 power supply is displayed as Detected PSU = “PSU-HV”.