Lantronix
SM24TBT2DPB Install Guide
33845 Rev. B
Page
22
of
48
Installing SFP Modules
You can install or remove a mini-GBIC SFP module from an SFP port without having to power off the switch.
Note
: The SFP ports should use UL Listed Optional Transceiver product, Rated 3.3Vdc, Laser Class 1. See the
SFP manual for specific cautions, warnings, and instructions. See the Lantronix
for our full range of
Optical Devices.
During installation and maintenance, avoid direct exposure to laser beams. Specifically, do not look into laser
ports. Ensure that each SFP port at which laser beams are (or will be) present is occupied by an SFP that is
locked in position.
1. Position the SFP device at either installation slot, with the SFP label facing up (Port 25) or down (Port 26).
2. Carefully slide the SFP device into the slot, aligning it with the internal installation guides.
3. Press firmly to ensure that the SFP device is firmly seated against the internal mating connector.
4. Attach an appropriate cable into the SFP module port.
5. Attach the other end of the cable to the other device.
Note
: Do not remove and replace SFP modules more often than necessary; excessive SFP removing/replacing
can shorten the SFPs useful life.
Grounding
ATTENTION
:
This case must be earth grounded.
No DC input may be earth grounded.
Use Isolated Power Supply.