Lantronix
SM24TBT2DPB Install Guide
33845 Rev. B
Page
27
of
48
If Using AC Power
1. Connect the Saf-D plug of the Saf-D adapter cord to the Saf-D receptacle on the switch power supply.
2. Connect the IEC plug end of the Saf-D adapter cord to the IEC receptacle end of the power cord.
3. Plug the power cord into an AC wall outlet.
4. Check the SYS LED. If it is ON, the power connection is correct.
If using two power supplies, repeat steps 1-4 for the second power supply.
If Using DC Power
1. Connect the Saf-D plug of the Saf-D adapter cord to the Saf-D receptacle on the switch power supply.
2. Cut off the receptacle end of the Saf-D adapter cord, strip the insulation on each wire back approximately
0.25" (6mm). Twist the stranded wire ends to facilitate connection of the wires to an appropriate DC power
source of your choice, ensuring the specifications meet the designated DC power requirements. (See “PS-
ACDC-1200 Output Specifications” for acceptable DC power source specifications).
If Using Digital Electricity™ (DE)
1. Follow the DE equipment provider's instructions to connect the Saf-D plug on the cable to the Saf-D
receptacle on the switch's power supply.
* Digital Electricity is a trademark of VoltServer. For more information about Digital Electricity, visit