Lantronix SM TAT4X Series, Install Manual

Page: 13 / 43

Lantronix SMxxTAT4Xx Install Guide
33785 Rev. F https://www.lantronix.com/ 13
Remote Monitoring
(RMON) Embedded RMON agent supports RMON groups 1,2,3,9 (history, statistics, alarms,
and events) for enhanced traffic management, monitoring and analysis
Firmware Upgrade

Web browser upgrade (HTTP/ HTTPs) and TFTP

Upgrade via console port as well
Configuration
Backup/Restore
Save and update the config files controlling the switch
Port Mirroring
Traffic on a port can be mirrored to another port for analysis with a network analyzer
or RMON probe. Up to N-1 (N is Switch’s Ports) ports can be mirrored to single
destination port. A single session is supported.
IEEE 802.1ab (LLDP)

Used by network devices for advertising their identities, capabilities, and
neighbors on an IEEE 802ab local area network

Support LLDP-MED (ANSI/TIA-1057) extensions
UPnP
The Universal Plug and Play Forum was formed to standardize discovery and control
of networked devices. See the Open Connectivity Foundation
webpage .
CDP Aware
CDP operation is restricted to decoding incoming CDP frames (the switch doesn’t
transmit CDP frames). CDP frames are only decoded if LLDP on the port is enabled
s-Flow
The industry standard for monitoring high speed switched networks. It gives complete
visibility into the use of networks enabling performance optimization,
accounting/billing for usage, and defense against security threats
Web GUI Built-in switch configuration utility for browser-based device configuration
CLI Lets you configure/monitor/diagnose switch in Command Line mode
Dual Image Independent primary and secondary firmware images for backup while upgrading
NTP
Network Time Protocol (NTP) is a networking protocol for clock synchronization
between computer systems over a packet-switched network
Switch Management

HTTP/HTTPs

SSH

DHCP Client/ DHCPv6 Client

Telnet Client

IPv6 Management
Diagnostics

Cable diagnostics

Ping

Syslog

Traceroute