Lantronix LSB4, Reference Manual, Page: 23 / 74

LSB4 Reference Manual Port Commands
4-3
Set/Define Port (cont.)
Parameters Character Size
Sets the character size for the current port.
Command Completion
When enabled, completes a keyword when a keyword is be-
ing entered and the space bar is pressed.
Flow Control
Specifies the type of flow control for transfer to and from a
port. Flow Control choices consist of XON/XOFF software
handshaking protocol, CTS/DSR hardware handshaking pro-
tocol, or no (None) protocol.
Modem Control
Enables or disables manipulation of modem control signals.
When this parameter is enabled, the LSB4 will operate as if
there is a modem connected to the serial console port. Specif-
ically, the DTR signal will drop when the modem connected
to the serial console port logs out. The LSB4 will assume a log
out when the DSR signal (provided to the serial console port)
drops.
When disabled, the LSB4 will ignore the status of DTR and
DSR signals.
Parity
Specifies a parity setting of Odd, Even, Space, Mark, or None.
Speed
Specifies one of the following baud rates: 300, 600, 1200, 2400,
4800, 9600, 19200, 38400, 57600, 115200.
Type
Use this parameter to specify the desired output from the se-
rial console port.
If ANSI is selected, the output will contain cursor movement
key characters and editing command characters.
Softcopy limits the transmission of special characters to the
backspace/delete key only. Softcopy is used on devices that
do not support the ANSI characters.
Hardcopy removes all special characters except carriage re-
turns and line feeds. Hardcopy can be used when the serial
console port is connected to a printer.
Examples
Local> SET PORT SPEED 38400
Local> SET PORT FLOW XON
Local> SET PORT COMMAND ENABLED
The default Flow
Control setting is
XON .
The default Charac-
ter Size is
eight .
The default
Parity setting is
None .
The default baud
rate is
9600 .
The default Type is
ANSI .