Unattach Port
Command Reference
12-118
Errors
This is a LAT lookpback test only. Testing a Local, Login or proxy Telnet
service will fail; use Test Port if you are unsure of the connection to a local
service.
Parameters
Count
Governs the number of test lines that will be sent. Generally, the count value
can be any whole number. If a count is not specified in the command, the ETS
will continue to produce character streams until a key is pressed.
Destination
The test stream will be sent to the specified port on the LAT device.
Node
The test stream will be sent to the specified node of the LAT destination port.
PostScript
Performs a bidirectional data test of the interface between the ETSand the
printer. This test will not generate any paper output. Instead it should echo the
PostScript data back to the ETS and issue a status message on the result of the
test.
Note:
Autosensing printers must be locked into PostScript mode for this test to succeed.
Width
Breaks the stream of ASCII characters into lines that are each width characters
long. The width value can range from one to 133. The default is 70 characters.
Examples
Local> TEST Service ALEX COUNT 1000 WIDTH 80
See Also
Set/Define Server Incoming, page 12-68; Set/Define Service Virtual, page 12-
92.
12.60 Unattach Port
Detaches a previously Attached port. Use Disconnect to disconnect your own port. Use Logout Port to
disconnect all sessions and to logout a port.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Examples
Local> UNATTACH PORT 5
UNATTACH PORT portnum