Configure
UDS-10 User Guide
3-21
3.6.6 Remote IP Address
This is the destination IP address used with an outgoing connection.
3.6.7 Remote Port
The remote TCP port number must be set for the unit to make outgoing connections. This
parameter defines the port number on the target host to which a connection is attempted.
Note: To connect an ASCII terminal to a host using the unit for login purposes, use the
remote port number 23 (Internet standard port number for Telnet services).
3.6.8 DisConnMode
Note:
See Table 35 - Binary to Hexadecimal Conversion Table.
Table 12 - Disconnect Mode Options
Disconnect Mode Option 7 6
5
4 3 2
1 0
Disconnect with DTR drop
(6)
1
Ignore
DTR
0
Telnet mode and terminal
type setup
(1)
1
Channel (port) password
(2)
1
Hard disconnect
(3)
0
Disable
hard
disconnect
1
State LED off with connection
(4)
1
Disconnect with EOT (^D)
(5)
1
1. The CoBox will send the "Terminal Type" upon an outgoing connection.
2. A password is required for a connection to the serial port from the network.
3. The TCP connection will close even if the remote site does not acknowledge the disconnection.
4. When there is a network connection to or from the serial port, the state LED will turn off instead of blink.
5. When Ctrl D or Hex 04 are detected, the connection is dropped. Both Telnet mode and Disconnect with EOT must be enabled
for Disconnect with EOT to function properly. Ctrl D will only be detected going from the serial port to the network.
6. When DTR on the CoBox/UDS product transitions from a high state to a low state, then the network connection to or from
the serial port will drop.
