NCA-1020 User Manual
27
The motherboard supports a 204-pin DIMM DDR3L 1600 MHz non-ECC up to 8GB, which is located on the
bottom side of the motherboard. Please follow the steps below to install the DIMM memory module
properly.
Note
: you may have to remove the SSD installation bracket first.
1.
Assuming that the previous steps, including system power-off, lifting the chassis and removal of the
SSD bracket, have been taken properly, then remove the 4 screws at the four corners that secure the
motherboard.
2.
Gently take the motherboard out of its original place.
