Chapter 3. BISO Setup
30
User’s Manual
Power Button Function:
This feature sets the function of the power button. Settings:
On/Off
The power button functions as normal on/off button.
Suspend When you press the power button, the computer enters the suspend/sleep mode, but if the
button is pressed for more than four seconds, the computer is turned off.
Restore on AC/ Power Loss:
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
Power Off
Leaves the computer in the power off state.
Power On
Reboots the computer.
Last State
Restores the system to the status before power failure or interrupt
occurs.
Resume On PME/LAN:
When setting to Enabled, this feature allow your system to be awakened from the
power saving modes through an incoming call from a signal from the LAN, or any event on PME (Power
Management Event). Settings: Enabled and Disabled.
Note: You need to install a LAN card supporting power on function for Resume on PME/LAN function.
Resume On RTC Alarm:
This is used to enable or disable the feature of booting up the system on a schedule
time/ date. Settings: Enabled and Disabled.
Alarm Date/Hour/Minute/Second:
If Resume On RTC Alarm is set to Enabled, the system will
automatically resume (boot up) on a specific date/hour/minute/second specified in these fields. Available
settings for each item are:
Alarm Date
01~31, Every Day
Alarm Hour
00~23
Alarm Minute
00~59
Alarm Second
00~59
