24 / 26
4 Assembly Instructions for Electrical Part
Following the installation of the mechanical components on the cab and the mounting of the cab doors, the
door must be calibrated once. The following conditions must absolutely be observed:
Any existing shaft locking weight must not bounce
The cab doors and all the shaft doors must move easily.
The toothed belts must be taut (one should only be able to depress it in the centre by two fingers).
The connector rail X1 (inputs) and X2 (outputs) must be stripped temporarily for calibration pur-
poses.
NOTE:
We refer to the further calibration of the door contained in the enclosed Operating Instruc-
tions for the door control unit and the manual for TSG electronic for sinus drive at this time.
