Manual radarTOUCH
Version 3.4
T. Schwirten LANG AG
14.10.10
Page 21
mouseVersion == 3
This Version keeps the left mouse button clicked as long as the obstacle stays in the
active area. Compared to version 1, it does not scroll the wheel if two objects are
detected. No matter how many objects are detected, it simply tracks on the first
obstacle that was detected and follows it with the mouse.
allowStartingTwice
Usually the software can not be started twice. For some reason it might be needed to run the
software two times on one computer. This can be done with setting this parameter to true. Be
aware of the fact that you can not connect two times to one radarTOUCH measurement
device. If you want to use two units, you have to change the IP address. For this please refer
to chapter “5.2 Changing the IP address of the measurement device “
startMinimised
If this Boolean variable is true, the GUI starts minimised to the task bar.
wideWorkingRange
If you want to use the radarTOUCH in very large distances (>12m), you should set this
parameter to true. It has the effects on the software that the range of the sliders in the GUI is
larger
minObjectSizeIs_1
Just like the parameter above, this is useful if you use the radarTOUCH in very large
distances. If you are not using the device that way it should always be set to false.
flipXandY
If this parameter is set to true, the x- and y-coordinates in the TUIO data are flipped. That
means x becomes y and y becomes x.
maxDistance
and
maxAngularDistance
Sometimes it is useful to reduce the resolution which the radarTOUCH offers. Some users
point with their hand at a button and not with just one finger. If they use the hand, the system
might detect a few more blobs than just one. This might trigger some wrong events. You can
reduce the resolution by setting these two parameters higher than zero.
maxDistance
describes the maximum distance in mm for two obstacles to be detected as
one.
maxAngularDistance
describes the maximum distance angular measurements that could
be between two obstacles to be detected as one.
If both parameters are set to zero, the system uses the normal algorithm for detecting
obstacles. If you choose to use them, the system uses a different algorithm that has its
strengths performing some sort of a blob reduction.
trackingSettings
You should not change anything here!
Summary of Contents for Radar Touch RT500
Page 1: ...Manual Version 3 4...
