Manual radarTOUCH
Version 3.4
T. Schwirten LANG AG
14.10.10
Page 16
4.1.2 MultiBlobViz
If you are ready with setting up the active area you can use the test program which will help
you to do some fine adjustments. This tool is called “MultiBlobViz”, you will find it under
Options
Start MultiBlobViz.
What it does is to receive TUIO data on port 3333 and draws circles on the corresponding
screen position (see also chapter 4.2.2 Open sound control (OSC): TUIO). Make sure that
your PC on which you are running the radarTOUCH software, has the IP address to which
you are sending the TUIO data.
By using the arrow keys you can change the position and size of your active area:
Arrow keys up, down, left, right
Changes horizontal and vertical offset
CTRL + arrow keys up and down
Changes active height
CTRL + arrow keys left and right
Changes active width
The small icons in the lower part of the screen will help you during your adjustments.
You are only changing the active area which has the focus in the PreViz window.
You can leave this application by pressing ESC but keep in mind that you have store your
new settings are not stored automatically.
Figure 24 MultiBlobViz test program
The middle of a blob should be the middle of you finger, then the active area was set up
correctly. Check the center and also the boarders of your screen.
Summary of Contents for Radar Touch RT500
Page 1: ...Manual Version 3 4...
