UL File# MH19366
8
Installation
WARNING
INSTALLATION OF THE UNIT MUST BE DONE BY PERSONNEL QUALIFIED
TO WORK WITH PLUMBING. IMPROPER INSTALLATION CAN CAUSE
INJURY TO PERSONNEL AND/OR DAMAGE TO EQUIPMENT. UNIT MUST
BE INSTALLED IN ACCORDANCE WITH ALL APPLICABLE CODES.
NOTICE
The data plate is located above control panel behind wire mesh screen.
The oven serial number, gas specifications, and clearance specifications
are on the data plate. This information should be carefully read and
understood before proceeding with the installation.
NOTICE
The installation of any components such as a vent hood, grease
extractors, fire extinguisher systems, must conform to their applicable
National, State and locally recognized installation standards.
Leg Installation
Legs are available for both the single and double deck installations. Single
deck installations require a 27-inch leg. Double deck installations require 6-
inch legs or casters.
To install the 27-inch legs, place some cardboard on the floor and gently tip
the oven onto its back. Fasten two legs to the oven's front corners using
the four 5/16 inch bolts provided in the leg kit. Lift the oven onto its front
legs and block the back up using one of the 27-inch legs set upside down in
the center rear of the oven body. Install the last 27-inch leg onto the oven
body on the control side rear. Gently lift the oven rear, remove the leg set
to support the oven center and install it on the last rear corner.
To install the 6-inch legs or casters, follow the instructions in the Leg Pad
section on the following pages or in the Leg Pad box supplied with the
oven.
The adjustable feet on the bottom of each leg may be screwed in or out as
necessary to level the oven.
A torpedo level placed on an oven rack will assist in leveling the oven.
Stacking the Ovens
Remove all the plug buttons from the top of the lower oven.
Remove the stacking kit from the oven compartment of one oven and install
the 1 1/4-inch plastic bushing into the top of the lower oven.
Tip the top oven backwards and install two 3/8-inch socket head bolts,
found in the stacking kit, into the two front leg holes that match the holes in
the top of the lower oven. Install the socket head bolts with the heads of
the bolt pointing away from the oven.
Lift the top oven and gently set on top of the lower oven so that the heads of
the socket head bolts nest into the holes in the top of the lower oven.
