E4
CAUTION Avoid Installing The Sling On Sharp Edges That Might Damage It. Whether
You Are Using A Post, A Tree Or A Stump, Always Install The Sling Near The Anchor's
Base.
ROPE INSTALLATION
The great variety of situations encountered when winching prevents us from providing specific
instructions; however you need to consider the following points:
1. Rope
Use a low stretch rope, in good condition, with a minimum diameter of 10 mm (3/8") and a
maximum diameter of 12 mm (1/2")
，
with good knots. Use pulleys to redirect the rope and to
multiply the pulling capacity when the load is near or over the pulling capacity of the winch.
2 .Pulley
Using a pulley at some distance in front of the winch offers many advantages:
●Pulling angle lifts' the load and reduces friction;
●The winch is maintained at a relatively horizontal position;
●Winch and operator are away from the load's path.
3. Direction
Install he rope in such a way that t does not rub against other objects Ty to set-up the rope so
that the front of the load is slightly lifted. Do not pull downwards or through an obstruction.
Generally, if the rope touches the ground while pulling, your installation is incorrect
4. On a hill
WARNING do Not Pull A Load Directly Toward The Winch In A Downward Sl Ope Since It
Could Slide Without You Being Able To Stop It. In That Situation, Use A Pulley At The
Bottom Of The Hill And Position The Winch Outside Of The Load's Path.
5. Pulling a load
WARNING check winch position, rope condition, solidity of the anchor pointe knots
carabiners or shackles in order to prevent injuries or material damage.
OPERATION
1.Completely insert the battery into the power head along the card slot until the battery button
bounces up. To remove the battery, press the battery button, grab other sides of battery with
other four fingers, and then pull the battery out.(Figure.3)
Battery pack
Battery pack button
Fig.3
