IMPORTANT SAFEGUARDS
For your own safety, please always follow the following basic precautions
when using this product. Failure to observe these instructions could lead
to serious injury or death.
WARNING
CHEMICAL AND FIRE HAZARD
1. Always Know Your Pulling Tool. Take time to fully read the Installation and
Operator's Guide, in order to understand your pulling tool and its operations.
2. Always wear gloves, eye and ear protection.
3. Never store battery pack in a tool box or pocket with nails, screws, keys, etc.
Shorting of battery terminal may cause fire.
4. Always avoid contact with battery leakage, which may occur under extreme
usage or temperature conditions.
5. Always dispose or recycle battery according to local ordinances I regulations.
6. Always protect terminals with insulating tape, prior to disposal, to prevent
shorting.
7. Never attempt to disassemble the battery. No user serviceable parts are
inside.
8. Never charge damaged battery packs, replace damaged pack immediately.
Battery short or fire may result.
9. Never incinerate the battery pack even if it is severely damaged or is
completely worn out.
10. Never operate pulling tool in an environment containing explosive or
combustible material.
11. Always remove the battery when the unit is not in use.
12. Never charge damaged battery packs, replace damaged battery pack
immediately. Battery short or fire may result.
CHARGER USE
1. Always fully charge battery before use.
2. Always use Landworks charger to charge Landworks type battery pack,
Other types of batteries may burst causing damage and injury to person.
3. Never operate charger with damaged cord or plug. Replace them immediately.
4. Never use Landworks charger to charge other batteries.
ELECTRICAL HAZARD
1. Always use properly grounded single phase receptacle protected by a ground
fault circuit interrupter (GFCI).
2. Never remove ground pin from plug.
3. Never route electrical cables across sharp edges.
4. Never route electrical cables through or near moving parts.
5. Never route electrical cables near parts that become hot.
6. Never remove electrical cover from battery charger.
7. Never leave the puling tool power cord plugged in when installing, rigging,
servicing or when the puling too is not being used.
8. Never operate charger if it has received a sharp blow, been dropped or
otherwise damaged in any way.
