Landoll VT Plus 7550, Operator'S Manual

Page: 68 / 96

3-52 F-987-0519
ASSEMBLY INSTRUCTIONS
Final Assembly
1. Attach a tractor to the implement and charge the lift
system hydraulics as described is
“Hydraulic Lift
System” on page 4-3 .
2. Connect the hydraulic hoses on the optional
hydraulic leveler to the tractor (if equipped). Fully
extend and retract the hydraulic leveler several times
to remove any air.
See “Leveling Front-to-Rear” on
page 4-12 for any further adjustments
3. The fold system must be purged of air and filled with
oil BEFORE attempting to fold the implement. Air in
the system will allow the wings to fall uncontrollably
and may result in implement damage. Follow
instructions for charging the hydraulic fold system as
described in
“General Operation” on page 4-8 .
4. Connect lights to the tractor and verify operation.
5. Check tires for proper inflation
6. Level the disc from side to side as described in
“Leveling (Side to Side)” on page 4-10 .
7. Inspect the final implement assembly, and verify that
all bolts have been tightened, cotter pins spread, and
that there are no leaking hydraulic connections.
8. Rotate each disc gang to verify that each gang
rotates freely. Adjust any scrapers that may have
shifted during shipment or assembly.
9. Lubricate the disc at all locations (See “Lubrication
Maintenance” on page 4-22.)
10. Touch up with paint any areas that may have been
scratched during moving, handling, or assembly.
11. Thoroughly read and understand the operating
section before using the disc.