Landoll Brillion SS16, Operator'S Manual

Page: 46 / 100

2-28 F-1021-0422
TABLE OF CONTENTS
Console w/Clutch Control
Electrical Layout - Optional
The clutch is controlled by a toggle switch on the
Console.
1. Route Clutch Harness along front frame tube of
seeder and under SMV Bracket, with 2 Spade
Connector to the Left /Clutch Transmission and the
3-Pin Connector to the Right/Seed Shaft Sensor.
Route Clutch Harness Center Plug (6-Pin) through
SMV Bracket bottom opening and insert plug into the
front facing cut out. Secure with two M5-.08 x 14
BHCS Screws.
See Figure 2-26.
2. Connect either 4 ft (3-PT) or 20 ft (Drawbar)
Extension Harness to the Clutch Harness. Route
along 3-PT Hitch or Drawbar towards front of
machine.
See Figure 2-25.
3. Plug 2 Spade connector to the Clutch Shaft Assembly
Cable.
4. Plug 3-Pin Connector into the Seed Shaft Sensor.
5. Secure Harnesses with tie straps after Nylon Tubing,
Harnesses and Hydraulic Hoses if (applicable) have
been installed.
Figure 2-25: Clutch and Seed Shaft Sensor Schematic
Console
Clutch Harness
Seedshaft
Sensor
Clutch Shaft
Assembly
4 Ft Extension Harness
(3-PT Hitch Model)
or
20 Ft Extension Harness
(Drawbar Model)
SSP16 ConsoleSchematic
2 Spade
Connector
3-Pin
Connector
9-Pin
Connector
3-Pin
Power Plug