Landoll Brillion SS16, Operator'S Manual

Page: 25 / 100

F-1021-0422 2-7
TABLE OF CONTENTS
3-PT Hitch Air System
Installation
1. Cut the Nylon Tubing into two equal lengths,
approximately 15ft each. Set aside.
2. Screw the coated threaded male end of the Push to
Connect Elbow into each air springs port. Insert a
Nylon Tube end into each Push to Connect Elbow.
3. Route the Nylon Tubing along the left and right sides
of frame and up the 3-PT Hitch. See Figure 2-6.
4. Cut off any excess Nylon Tubing and insert ends into
the Air Manifold Assembly Push to Connect Elbows.
Cut ends of Nylon Tubing should be smooth and burr
free. Burrs can cause slow leaks.
5. Secure Nylon Tubing with tie wraps after all
Harnesses have been installed.
6. When Assembly is complete, pressurize the Rear
Roller Air System . See “Rear Roller Air System” on
page 3-7.
Figure 2-6: 3-PT Hitch Air System
SSP16 OpAirSystem
Push to Connect Elbow
,
1/4 OD x 1/8 NPT
Air Manifold Bracket
Air Spring
Air Manifold
Nylon Tubing
1/4" OD
Nylon Tubing, 1/4" OD
Nylon Tubing, 1/4" OD