Landoll 900B Series, Operator'S Manual

Page: 33 / 82

3-21
3-17 HYDRAULIC POWER SUPPLY ENGINE OPERATION (OPTION)
3-17.1 The Hydraulic Power Supply Engine
system is used to power the hydraulic func-
tions, should the tractor not be equipped with
hydraulic hookups.
IMPORTANT
1. CHECK THE FOLLOWING FLUID LEVELS BE-
FORE STARTING THE ENGINE PACKAGE: EN-
GINE OIL, FUEL SUPPLY, HYDRAULIC OIL.
2. IF THE ENGINE DOES NOT CRANK, CHECK
THE FOLLOWING ON THE BATTERY: CHARGE,
FLUID, TERMINALS, AND CABLES. TAKE COR-
RECTIVE ACTIONS AS NEEDED.
CAUTION
IF THE HYDRAULIC FLUID LEVEL IS
LOW DURING OPERATION, THE SEMI-
TRAILER MAY NOT OPERATE COR-
RECTLY, RESULTING IN DAMAGE TO
THE SEMITRAILER.
3-17.2
The ENGINE IGNITION SWITCH is lo-
cated below the hydraulic controls, and
ahead of them on the driver’s side of the
semitrailer. Use the key to start and stop the
Hydraulic Power Supply Engine.
(See Figure
3-9). This switch has three positions:
OFF In this position, the power pack-
age engine does not run. The
key can only be inserted or re-
moved from this position.
RUN In this position, the engine runs
without activating the starter.
START In this position, the starter cranks
the power package engine, to
start
it. After the engine is
started, release the key to the
RUN position.
3-17.3
The HYDRAULIC POWER SUPPLY
ENGINE CHOKE (See Figure 3-9) is located
to the right of the Engine Ignition Switch on
the driver’s side of the semitrailer. The pur-
pose of the Choke is to aid the starting pro-
cedure.
mem950b-51-ctrl-pnl
LANDING GEAR CONTROL
ENGINE IGNITION SWITCH
ENGINE THROTTLE
ENGINE CHOKE
Figure 3-9 Hydraulic Engine Package Control Panel