Landoll 850 FINISHOLL, Operator'S Manual

Page: 51 / 74

3-11 LEVELING ASSEMBLY INSTALLATION
IMPORTANT
SEE FIGURE 3-19 FOR PART NAMES.
3-11.1 Install the spring bushing in the pivot
block.
3-11.2 Lightly coat the threads of the 1"-8 X 4
screws with locktite. Use the screws, flat
washers and lockwashers to secure the
pivot block bushings and the pivot block be-
tween the arms extending from the gauge
wheel rockshaft.
3-11.3 Assemble the pivot bracket on the front
bolt and bushing in the mast with the short
arm up and forward as per decal on bracket.
Failure to do so will cause damage.
3-11.4 Slide a leveling spring onto the
threaded end of the leveling rod.
3-11.5 Slide the leveling rod into the pivot
block and pin to the pivot bracket with a pin
and 3/8-16 X 3-1/2 screw and lock nut.
3-11.6 Install a washer, leveling spring,
washer, nut and jam nut on the leveling rod.
Thread the nut completely onto the leveling
rod and lock with a jam nut.
3-11.7 Install the radius rod between the pull
hitch and the upper end of the pivot bracket
with pins, cotter pins and a 3/8-16 X 3-1/2
screw and lock nut.
3-12 OPTIONAL HYDRAULIC RADIUS ROD
IMPORTANT
SEE FIGURE 3-21 FOR PART NAMES.
3-12.1 Remove the clevis from the cylinder
rod, apply loctite to the threads, and assem-
ble the cylinder to the radius rod.
3-12.2 Remove the nuts from the two tie
screws on the left side of the cylinder on the
rod end and install the gauge bracket.
3-12.3 Install the 1-1/4" O.D. bushing inside
the 1-5/8" O.D. bushing in the upper end of
the pivot bracket.
3-12.4 Install the base end of the cylinder to
the upper end of the pivot bracket.
3-12.5 Install the adjustable end of the radius
rod to the pull hitch with the pin and cotter
pins.
3-19