Landoll 850 FINISHOLL, Operator'S Manual

Page: 45 / 74

3-7 SHANK INSTALLATION
3-7.1 Mark shank locations per the shank
placement drawing for your size unit.
3-7.2 Install shanks and clamps. (See Figure
3-12 ).
a. Spring clamp assembly - Install clamp as-
sembly to frame using U-bolt and serrated
flange nuts. Install shank in clamp using 5/8-
11X 1-3/4 screw and flange lock nut provided.
To facilitate installation of the U-bolt nuts, re-
move the screw at the top of the spring and
swing the spring out of the way.
b. S-shank assembly - Clamp shank to frame
with two plates, two 3/8-16 X 5 screws and
one 5/8-11 X 5 bolt and nuts provided.
c. C-spring assembly - Install C-spring on
frame with clamp, bracket, 3/8-16 x 3-1/2 car-
riage bolt, , 1/2-13 X 6 screws and nuts pro-
vided. Install shank in C-spring using 5/8-11 X
2 screw and flange lock nut provided.
3-7.3 Install sweep on shank with 7/16-14 X
1-1/2 screws, washers and nuts provided.
3-8 SMV BRACKET INSTALLATION
3-8.1 Install the SMV brackets close to the
center of machine on rear frame member.
Bolt together SMV mounting bracket and
warning light bar with 1/2-13 x 5-1/2 hex
head cap screws and 1/2-13 hex lock nuts
through holes in bracket parts so that brack-
ets are snug around frame member. (See
Figure 3-13).
3-8.2 Attach SMV emblem to SMV mounting
bracket using 1/4-20 x 1 hex head cap screw
and 1/4-20 hex lock nut.
3-13
Figure 3-13 SMV Bracket Installation