Landoll 6250 Disc, Operator'S Manual

Page: 33 / 94

ASSEMBLY INSTRUCTIONS
3-5
Figure 3-4: Dual Tire Scraper Installation
Dual Tire Scraper Installation
Refer to Figure 2-7 for dual tire scraper placement.
1. Attach scraper mount to center frame using u-bolts
and 3/4-10 hex lock nuts
(See Figure 3-4.)
2. On inner dual tires, attach scraper to scraper mount
in between dual tires using 3/4-10 x 1-3/4 hex head
cap screws and hex lock nuts.
3. On outer dual tires, attach scraper to scraper mount
in between dual tires using scraper plate, 3/4-10 x
2-1/4 hex head cap screws and hex lock nuts.
Inner Wing Frames
1. Place the inner wing frames on top of the wing gang
assemblies and attach using 3/4-10 x 2 and 3/4-10 x
8-1/2 hex head cap screws and hex lock nuts
(See
Figure 3-3.)
2. Assemble the tire and wheel assemblies to the wing
frames. The wings use 8 bolt wheels and 3” slip-in
spindles. Torque to 85 to 100 ft./lbs.
3. Assembly wing stabilizer and wing lock as shown on
the front and rear cross tubes.
IMPORTANT
Note the orientation as the rubber bumper must be
toward the outside and the 1/2-13 x 3-1/2 hex head
cap screws must be inserted from the bottom
through the wing rest mount and rubber bumper and
the flat washers and hex lock nuts located on top.