Landoll 6250 Disc, Operator'S Manual

Page: 40 / 94

3-12 F-733-1120
ASSEMBLY INSTRUCTIONS
Figure 3-10: Depth Stop Tube Installation
Depth Stop Tube Installation
1.
Attach the depth control mount plate to the lift using
3/8-16 x 1-1/4 hex head cap screws and hex lock
nuts.
2. Lay the depth stop tube assembly on top of the
center frame. Insert a 5/8-11 x 2-1/2 hex head cap
screw in the rear hole of the tube assembly from the
left side
(See Figure 3-10.) Install a 5/8-11 hex nut
on the screw. Do not over tighten, as the depth stop
must pivot on this screw. Insert the screw through the
depth stop mounting plate on the center lift and
secure with a 5/8-11 hex lock nut.
3. Insert 90º elbow fitting in the front of the limit valve.
4. Using 5/16-18 x 5 hex head cap screws secure the
front end of the depth stop tube assembly to the top
of the frame mount with the depth stop guide, slide
pad, and 5/16-18 hex lock nuts. Attach the limit valve
to the bottom side of the center frame mount using
these same screws.
IMPORTANT
It may be necessary to leave these screws loose to
attach the valve hoses later.