
PAGE 19
Pellet Kettle
Preparation for Use & Lighting Instructions
PRECAUTIONS:
• Read and follow all warnings on Page 3 and 4 of this manual, before operating the grill.
• For first time operation of the grill, please follow the “SET UP PROCEDURE” to ensure the auger tube is fully loaded with
pellets. For subsequent operation of the grill, please follow the
• “LIGHTING INSTRUCTIONS” to ignite the grill.
WARNING:
• Never add pellets to a hot fire pot by hand. You could be seriously burned. If the pellets run out or the fire goes out, wait
until the grill cools down, and then follow the “ SET UP PROCEDURE” to restart.
• Never put water in the fire pot as this could cause the auger to jam.
• Never use water to extinguish flare-ups. Close the lid and turn off the grill and wait for the fire to extinguish itself.
• Never use any flammable liquids, such as gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar
liquids, to start or freshen-up the fire! Keep all such liquids well away from the grill while it is in use.
SETUP PROCEDURE
Follow this procedure before first use and after every other use, or after a long cook time.
This should ONLY be performed when the grill is cool, before being used.
NOTE: During shipping or moving around your deck, some components may have shifted from position. A complete visual
inspection of the grill assembly is required. Follow these initial Setup Procedures to ensure proper and safe operation.
Step 1
Open the grill lid; remove the warming rack and cooking grates.
Step 2
Remove the Sear Plate / Grease Tray by removing the Sear Handle Clip and Washer, then slide out the Sear Handle, Lift up
the Sear Plate to remove.
Step 3
Inspect and clean the grease drain. Ensure the drain tube is not blocked.
Step 4
Inspect the bottom of grill body and clean out pellet ash. Also inspect and clean out fire pot. Ensure there are no foreign
objects in the fire pot and that the ignitor is clean and clear of debris.
Place the grill outdoors on a hard, level, non-combustible surface away from roof, overhang
or any combustible material. Never use on wooden or other surfaces that could burn. Place
the grill away from open windows or doors to prevent smoke from entering your house. In
windy weather or rainy weather, place the grill in an outdoor area that is protected from the
wind and rain.
Do not leave the meat probe inside of the grill for extended periods of time when cooking
at temperatures above 350F. The meat probe is not designed to withstand long periods at
temperatures higher than this. Only use the meat probe#PF0024 produced by Landmann for
this grill.
Read all safety warnings and instructions carefully before operating your grill.
Summary of Contents for 470220
