Information Functions Released
29/31
Cashpower Three Phase V11
– User Guide
© Gyr (Pty) Ltd
10.11 Power Limit Level (Register 014)
The meter displays the power level (in either Amps or Watts) at which the
load switch
will be opened,
causing the supply to the customer to be interrupted.
10.12 Instantaneous power on Phase 1 (Register 015)
The meter displays the instantaneous power being consumed by the connected load on phase 1 only.
10.13 Instantaneous power on Phase 2 (Register 016)
The meter displays the instantaneous power being consumed by the connected load on phase 2 only.
10.14 Instantaneous power on Phase 3 (Register 017)
The meter displays the instantaneous power being consumed by the connected load on phase 3 only.
10.15 Creep Lock Indication
This is the threshold below which no metering takes place. When in
creep lock
i.e. no energy being
measured, the
power (kWh)
icon (5.1) on the LCD flashes on and off. When the creep threshold is
exceeded and metering becomes active, the icon assumes a steady state.
10.16 Extended Meter Number (Register 024)
The ‘extended meter number’ displays the ‘missing’ three digits of an (STS only) meter number in the
format ‘07- - - - - n’ where:
07 is the manufacturer code (07 for South African manufactured Gyr meters).
n represents the check digit.
10.17 Meter (Fixed) State Register 0 (Register 031)
The meter displays the state in which the meter currently is. Note that these values are stored in the
meter’s EEPROM and will be maintained even if the meter is powered down:
Meter (Fixed) State Register 0
Display
Function
(bracketed values apply for bit set to
1
)
1
XXX XXXX
Load switch inhibit (power limit lockout mode
– 30 minutes)
X
1
XX XXXX
(Significant reverse energy) metered
XX
1
X XXXX
Credit-metering (enabled)
XXX
1
XXXX
Meter (decommissioned)
XXXX
1
XXX
Meter NOT initialised (default key)
XXXX X
1
XX
Meter (in power limit trip - 30-seconds)
XXXX XX
1
X
Meter (out of credit)
XXXX XXX
1
Meter (tampered)
