Meter Operation - Prepayment Mode Released
17/31
Cashpower Three Phase V11
– User Guide
© Gyr (Pty) Ltd
6.5.1.3
Set 2nd Dispenser Key Voucher
Refer to
– 6.5.1.2.
6.5.1.4
Clear Tamper Voucher
If a meter has been
tampered
, normal operation can only be restored by entering a
clear tamper
voucher. Note that these vouchers also reset the
power-fail counter
– 10.22.
6.5.1.5
Set Power Limit Voucher
This voucher sets the power limit level for the meter
– 6.8.
6.5.1.6
Set Credit Levels Voucher (Proprietary Voucher)
On accepting a power limit level number, the meter sets the appropriate high and low
credit levels
.
These are the levels at which
the segments in the ‘wedge’ of the LCD
credit indicator
toggle
– 5.6.
6.5.1.7
Clear Credit Voucher
On accepting a
clear credit
voucher, the meter clears any remaining credit to zero and opens the
load switch, thus interrupting the electricity supply to the customer.
6.5.1.8
Initiate Dispenser Test Voucher (Meter Non-Specific Voucher)
There are a number of
non meter-specific
vouchers that can be used to test various functions on
the meter.
NB: These tests pertain to the meter and not the customer interface unit. They will
only be visible on meters fitted with a local display.
On accepting an
initiate dispenser test
voucher, the meter executes all the tests that are embedded
in that particular voucher. The following tests are supported:
Function
Voucher Number
Open the load switch
0000 0000 0001 5099 7584
HMI test - turns on all the
LED’s
, displays all
segments on the
LCD
, and activates the
buzzer
0000 0000 0001 6777 4880
Display the
total units counter
0000 0000 0002 0132 8896
Display the
key revision number
and
key type
1844 6744 0738 4377 2416
Display the
tariff index
3689 3488 1475 5332 2496
Display the
power limit
level
0000 0000 0012 0797 4400
Display the
tamper state
0000 0000 0022 8172 8512
Display the
instantaneous power
0000 0000 0044 2920 8064
Display the
software version
number
0000 0000 0087 2419 5840
Test all
the above functions (tests run sequentially)
5649 3153 7254 5031 3471
In a test sequence (
test all
), each test has a duration of 2.5 seconds, and is performed in the above
order. For a single test per voucher, the test has a duration of 5 seconds.
On completion of the test sequence, the meter returns to its normal mode of operation.
